I use KBR1 2 and my XSIID to login in my Virtual Machines but recently it is causing to freeze the Virtual Machines, I never had this problem before with past version like 16.00 or 17.00. Both my host O/S and Guest O/S are listed as fully supported by Workstation Pro v15 and higher (host), and specifically 15.5 for my guest O/S, Windows Server 2016 (64-bit).I have a VMware® Workstation 17 Pro 17.5.0 build-22583795 just updated earlier. Could it be the enhanced keyboard driver is having an issue not finding a physical keyboard attached? Please say that isn't it - I have MANY servers that don't have a one-to-one keyboard/mouse/monitor!Įdit: my pasted screen captures show in the forum editor, but not after saving this reply. Potentially relevant note: No keyboard, mouse or monitor are attached physically to the host O/S hardware. Windows Server 2016 Standard (64bit, the only architecture offerred), was listed as a supported Guest O/S). Dual Xeon's, and I did have to enable VT in two places in the BIOS setup, as warned by Workstation Pro upon first launch). Windows Server 2008 and above are listed as supported for the host O/S (I'm running Windows Server 2012 R2). ,Tech Specs, Host Operating Systems (64-bit). Version 15.5 surfaced only when I first launched Workstation Pro, it checked for updates, and found v15.5). at least that was the very recent results when I started (my initial purchase withing the past two weeks led me to Workstation Pro v15. Is there a known bug in WPro v15.5 in not properly installing the enhancekeyboard driver? Neither VMWare Workstation Pro or Server 2016 have been licensed/activated yet - I do have keys for each, but would prefer to see them working nearly optimally before registering them. Host is MS Server 2012 R2, guest is MS Server 2016 Standard with desktop experience, fresh install. VMWare enhanced keyboard is still unavailable, and the Windows logo key has no functionality in the Server 2016 guest O/S - full screen or not. And although I had both checkboxes enabled to remove configuration (and licensing), after reinstalled it "remembered" the VM I had created. Unexectedly, I was not prompted for a reboot afterwards. I finally resorted to uninstalling Workstation Pro (with both boxes checked, removed configuration and remove licensing). The only ramifications I've noticed so far is the Windows Logo key and its + N keystroke combinations are completely ignored while in the VM. I can start the VM, but w/o the enhanced keyboard driver. I finally downloaded the full installer and installed on top of the existing. On the host O/S, Programs and Features, I've used "Change" and verified the enhance keyboard driver check box was selected. Just in case it's important, I also installed vCenter Standalone converter (anticipating I'll have VM's running elsewhere I'll want to move to this host). That was a bit rocky, stumbling over the need to have Microsoft C++ Redistributable installed so the installed "tried", but never completed (separate thread, now resolved). This started as the lastest download at the time (v15), and upon installation checked for updates and immediately wanted to update to 15.5. It should be!? I've triple verified the checkbox is selected to install it (and noted the advisement that a restart of the host O/S will be required, and was prompted each time). But brand new VMWare Workstation Pro v15.5 shows in my guest VM I've created, under Settings.General, that the "VMWare enhanced keyboard driver is not installed on the host". I've searched docs and forums, followed the suggested steps, re-installed.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |